SPARE PARTS
FEEDER SPARE PARTS- SCREEN SPARE PARTS
- CRUSHER SPARE PARTS
- CONVEYOR SPARE PARTS
- SCREW WASHER SPARE PARTS
- BUNKER SPARE PARTS
Hopper Spare Parts
In hoppers, wear concentrates on the surfaces where material lands and slides. Renewing liners in time prevents the hopper body wearing through and costly structural repairs. CSP Mühendislik supplies liners and flow equipment for stock and feed hoppers.
Main Parts
- Wear plates and rubber liners
- Low-friction (UHMW-PE) liners
- Slide and flap gates, outlets
- Bin vibrators and air cannons
- Grizzlies and level sensors
Replacement and Stock Planning
- Use thick, tough liners in the impact zone and hard liners in the sliding zone
- Measure liner thickness periodically
- If bridging occurs, consider low-friction liners or a vibrator
- Check that the feeder matches the hopper outlet
Information Needed for Ordering
- Machine brand, model and serial number
- Part name and part number if available
- Photo and main dimensions of the old part
- Material or hardness preference and quantity
Frequently Asked Questions
What material should hopper liners be?
High-strength wear plate where impact and abrasion combine, and rubber or UHMW-PE liners for sticky material (wear plate).
Why does material hang up in a hopper?
Insufficient wall angle, a small outlet, damp and clayey material and rough or worn surfaces cause bridging.
Detailed guides: stock and feed hoppers, wear plates, feeder spare parts.